Sharp MX-M564N Operation Manual page 234

4
Press the [START] key.
Copying will begin.
If you have selected sort mode, change originals and press the [START] key. Repeat until all pages have been scanned and
then touch the [Read-End] key. (For the second original and following originals, use the same [START] key as you did for the
5
first original.)
To cancel scanning and copying...
Press the [STOP] key (
• The original must be placed on the document glass.
• The copy ratio is 100% when this function is used. The ratio cannot be changed.
• The staple and punch function cannot be used.
To cancel 11x17 Full Bleed...
Touch the [11x17 Full Bleed] key in the screen of step 3 so that it is not highlighted.
Place 12" x 18" (A3W) paper in the
bypass tray.
Pull out the extension tray, adjust the guides to the width of
12" x 18" (A3W) paper, and place the paper in the bypass tray.
After loading the paper, configure the bypass tray settings as
explained in
(page 2-38).
).
2-112
"MAKING COPIES USING THE BYPASS
Contents
COPIER
TRAY"