Sharp MX-M564N Operation Manual page 581

(2)
Scan/Special Modes
Verif.
Stamp
4
Press the [START] key.
Scanning begins. A beep will sound to indicate that scanning is finished.
5
To cancel scanning...
Press the [STOP] key (
• When two-sided originals are used, the front of each original is stamped twice.
• If an error occurs during scanning, an original that was not scanned may be stamped.
• When the "O" mark that is stamped on originals starts to become faint, replace the stamp cartridge. For the procedure for
replacing the stamp cartridge, see
MACHINE".
To cancel the stamp function...
Touch the [Verif. Stamp] key in the screen of step 4 so that it is no longer highlighted.
System Settings (Administrator): Default Verification Stamp
This setting is used to always have originals stamped.
(3)
(1)
OK
Blank Page
Skip
) to cancel the operation.
"REPLACING THE STAMP
Select "Verif. Stamp".
(1) Touch the
screens.
(2) Touch the [Verif. Stamp] key so that it is
highlighted.
(3) Touch the [OK] key.
CARTRIDGE" (page 1-79) in "1. BEFORE USING THE
5-95
SCANNER/INTERNET FAX
keys to switch through the
Contents