Advertisement
File No.
960-010
3.17.2 Operations
CAUTION:
After physical formatting is finished, enter the
MS-DOS FDISK command, which will set the partition. Then
enter the MS-DOS FORMAT command.
(See the MS-DOS manual for
details. )
1.
After pressing 2 and Enter in the DIAGNOSTICS MENU, the
following display will appear.
DIAGNOSTIC - HARD DISK FORMAT V2.00
1 -
~l
track FORMAT
2
Good track FORMAT
3
Bad track FORMAT
4
Bad track CHECK
9
Exit to DIAGNOSTICS MENU
Press [NUMBER] key ?
2.
All track FORMAT Selection
(1)
When all track FORMAT(l) is selected, the following
message will appear.
Drive number select (1:11, 2:12) ?
(2)
Select a drive number.
Type the drive number and press
Enter. The following message will appear.
Interleave number (3/1-3) ?
(3)
Select an interleave number.
(Usually select 3.)
Type
the number and press Enter. The following display will
appear.
[HOD TYPE]
[HOD TYPE]
[HOD TYPE]
CYLINDER
HEAD
SECTOR
=
=
=
XXX
X
XX
[WARNING : Current DISK data will be
completely destroyed]
Press [Bad track number (CCCH) key
?
[[cylinder,head
=
XXX
Xl]
(4)
After pressing the Enter, the [[cylinder, head
=
XXX
X]] message will appear; then all cylinders of the hard
disk are formatted and checked.
3-32
Advertisement
