File No.
960-010
PROCEDURE 6
New FDD Connection
1.
Turn off the power.
2.
Remove the FDD.
(Refer to section 4.12.)
3.
Connect a new FDD to the FDD connector without
installing the new FDD.
Then connect all of the FRUs
removed during FDD removal to their corresponding
connectors without installing the FRUs.
4.
Turn on the power.
5.
If normal operation is restored, the original FDD is
probably defective. Reassemble the system.
6.
If normal operation is not restored, the system board
is probably defective. Refer to section 2.4.
2-23