Advertisement
File No.
960-010
4. Plasma Font Type
This option specifies which display font the T3l00e uses each
time you start the system.
Single specifies light (single width) characters.
This is the preset value.
Double specifies heavy (double width) characters.
Use the Fn + right arrow to select the alternate character font
after the system is running.
5. Plasma Font Set
This option specifies which character font the T3l00e uses each
time you start the system.
Standard
North European
Canadian French
Reserved
6. Display Card
specifies the standard North American
character set.
THis is the preset value.
specifies the North European font.
specifies the Canadian French font.
This option lets you define the types of internal or external
display adaptor card you have attached to the T3l00e.
You only
specify this option when you install an optional video card in
one of the expansion slots.
The setup program displays your
choices a line at a time as follows:
Internal CGA (80*25)
Internal CGA (40*25)
External CGA (80*25)
External CGA (40*25)
External MDA (Internal CGA Enable)
External Other (Internal CGA Enable)
External MDA (Internal CGA Disable)
External Other (Internal CGA Disable)
Make a selection which corresponds to your hardware
configuration.
If you select a value which uses an external
display card, you must install an external display controller and
disable the internal display controller.
The preset value is the
first setting:
Internal CGA (80*25).
3-50
Advertisement
