Advertisement
File No.
960-010
3.24.2 Changing Setup Values
You can change the setup options automatically or manually.
Automatic Reset
Follow these steps to set the values automatically:
1
Press
FS.
This instructs the program to reset all the
options to their factory preset values.
The program
calculates how much conventional, extended and expanded
memory your T3100e has, based on whether or not you have a
memory expansion board installed.
Setup stores the value it
calculates in configuration memory along with the factory
preset values for the other options.
The [[System setup]]
menu displays the new values.
2
Confirm that the new values are correct.
To change any
option(s), go to the next section, Manual Reset.
3
If the new values are correct, press Fl. The system
restarts.
Manual Reset
Follow these steps to change any option(s) manually:
1
Notice the cursor (reverse display highlight bar).
This
cursor indicates which option is selected for change.
2
Use the up and down arrow keys (or Enter) to move the cursor
between options.
3
When the cursor highlights the value of an option you want
to change, use the left and right arrow keys to select
alternate values.
The possible values for each option are
shown in the table below.
4
When you are finished making changes, press FlO to record
the new values in configuration memory.
5
SETUP displays this message:
ARE YOU SURE
?
(YIN)
Review your changes.
If you need to make more alterations,
press N and go back to step 2.
6
If the new values are correct, press Y.
The system
restarts.
3-46
Advertisement
