Advertisement
File No.
960-010
PROCEDURE 3
Format Execution
CAUTION:
The contents of the hard disk will be erased when
the FORMAT command is run. Before running this test,
transfer the contents of the hard disk to floppy disks. This
can be done with the MS-DOS BACKUP command.
(See the MS-DOS
Manual for details.)
1.
Remove the diagnostics disk from the FDD, then insert
the MS-DOS system disk in.
2.
Make partition of the hard disk by entering the FDISK
command.
(See the MS-DOS Manual for details.)
3.
Format the hard disk by entering the FORMAT command.
(See the MS-DOS Manual for details.) At this time use
/S switch to transfer the system program.
4.
If normal operation is restored, the HDD is normal.
5.
If normal operation is not restored, go to PROCEDURE 5.
2-27
Advertisement
