Advertisement
Quick Links
Assembly Instructions
Original hands free phone kit for retrofitting
Scope of delivery:
◆
1 x Interface box
◆
1 x Microphone
◆
1 x Wiring set
Special tools, test and measuring equipment, and ancillaries required:
◆
Torx Allen keys (set)
◆
Dismantling key 3409
◆
Wiring harness repair set -VAS 1978-
◆
Vehicle diagnosis, measurement and information system, e. g. -VAS 5051A-
Procedure:
Note
◆
A competent workshop should install the original hands free phone kit. Special tools and the
accompanying literature specific to the car are required for fitting it. Incorrect fitting may lead to damage
to the car or the hands free phone kit.
◆
The retrofitting can be carried out in vehicles fitted with a factory radio/radio navigation system.
◆
After completing the fitting work, the car must be coded for operation with the mobile telephone using
a car diagnostics, measuring and information system.
◆
Secure the wires so that they cannot come into contact with any rotating or other moving parts and so
that they cannot chafe on any sharp metal or plastic edges.
◆
All rights to make technical changes reserved.
1.1
Fitting location
The following illustration shows the possible fitting locations and
the routing of the wires from the radio/radio navigation system to
the roof console.
1 - Microphone
◆
Fitting work on the factory installed fitting location in the
roof console
2 - Wiring harness
◆
Routing from the radio plug connector to the interface box
and below the storage compartment on the passenger
side, the A-pillar trim and the roof lining to the microphone
in the roof console
3 - Interface box
◆
Possible fitting locations are, depending on the vehicle and
equipment installed, on the left next to or above the
storage compartment on the passenger side, below or
behind the radio/radio navigation system
CAUTION!
●
The wiring set -2- must be routed so that the function of
the passenger airbag is not limited.
●
The fitting location of the interface box -3- must be selected
so that the function of the passenger airbag is not limited.
1.2
Preparing the vehicle for fitting the component
−
Switch off the ignition and all electrical equipment.
−
Remove the radio/radio navigation system, the storage
compartment of the passenger side, the right hand A-pillar
trim, the sun visors and the roof console of the vehicle.
⇒
Vehicle repair manual
Distribution and Copyright by Volkswagen Zubehör GmbH 2008
◆
1 x Fitting material
◆
1 x Instruction manual
◆
1 x Assembly instructions
120
140
160
180
200
220
1K0 051 437
1
2
3
VOT-1546
1
Advertisement
Related Manuals for Skoda 1K0 051 437
Summary of Contents for Skoda 1K0 051 437
- Page 1 Assembly Instructions 1K0 051 437 Original hands free phone kit for retrofitting Scope of delivery: ◆ ◆ 1 x Interface box 1 x Fitting material ◆ ◆ 1 x Microphone 1 x Instruction manual ◆ ◆ 1 x Wiring set...
- Page 2 Original hands free phone kit for retrofitting Fitting the interface box − Plug the blue multiway connector of the wire set into the connector socket of the interface box and lock it. − Wrap the interface box with the foam material provided to avoid noises when the vehicle is moving.
- Page 3 Original hands free phone kit for retrofitting − Insert the single core wires of the wiring set into the radio connecting plug according to the following table. Tick-off the changes made in the table column "completed". wire colour to PIN/radio connecting plug completed orange/violet PIN 9...
- Page 4 Original hands free phone kit for retrofitting Coding the hands free phone kit − Connect a vehicle diagnosis, measurement and information system to the vehicle. − Select the operating mode "Vehicle Self-Diagnosis" at the vehicle diagnostics, measurement and information system. −...