Advertisement
Original hands free phone kit for retrofitting
1.1
Fitting the interface box
−
Plug the blue multiway connector of the wire set into the
connector socket of the interface box and lock it.
−
Wrap the interface box with the foam material provided to
avoid noises when the vehicle is moving.
−
Fit the interface box on a suitable fitting location on the
dashboard (see page 1, Fig. 1).
1.2
Routing the wiring set
−
Install the shorter section of the wiring set from the interface
box to the radio plug connector of the vehicle.
−
Install the longer section of the wiring set from the interface
box within the dashboard, to the A-pillar of the vehicle.
−
Secure the wiring set with the supplied cable ties within the
dashboard to the existing car wiring or supports of the vehicle.
−
Route the wiring set to the installation location of the roof
console alongside the A-pillar and within the roof lining.
−
Secure the wiring set with the supplied cable ties to the
existing car wiring or supports of the vehicle.
1.3
Fitting the microphone into roof console
−
Remove the cover from the (no illustration) mounting opening
of the microphone -1-.
−
Clip the microphone -1- supplied into the roof console of the
vehicle.
−
Connect the plug connection of the microphone to the socket
-2- of the wiring set.
−
Wrap the plug connection the foam material provided to avoid
noises when the vehicle is moving.
−
Refit the roof console in the reverse order.
⇒
Vehicle repair manual
1.4
Connecting the wire set to the radio connecting plug
of the vehicle
Note
Existing wiring is not illustrated below for reasons of clarity.
−
Pull the locking pin -2- out of the radio plug connector -1-.
−
Push the cable marked from the chamber of the radio plug
connector and lock the contacts into the supplied flat contact
housings -7- and -8- according to the table. Tick-off the changes
made in the table column "completed".
Wire colour
from PIN radio
connecting plug
orange/violet
PIN 9 (-3-)
orange/brown
PIN 10 (-4-)
yellow/red
PIN 15 (-5-)
brown
PIN 12 (-6-)
−
Lock the connector -7- and -8- into the respective socket of the
wiring set.
2
to PIN/plug
comp.
PIN 1 white plug
PIN 2 white plug
PIN 1 black plug
PIN 2 black plug
1
2
1
8
7
VOT-1547
2
3
4
5
6
VOT-1548
Advertisement
