Parts Name Of Remote Controller - Toshiba MMD-AP0071SH-C Service Manual

3-3. Parts Name of Remote Controller

Display section
In the display example, all indicators are displayed for the explanation.
In reality only, the selected contents are indicated.
• When turning on the leak breaker at the first time, [SET DATA] flashes
on the display part of the remote controller. While this display is flashing,
the model is being automatically confirmed. Accordingly, wait for a while
after [SET DATA] display has disappeared, and then use the remote
controller.
2
1
3
4
5
6
15
1
SET DATA display
Displayed during setup of the timer.
2
Operation mode select display
The selected operation mode is displayed.
3
CHECK display
Displayed while the protective device works or a
trouble occurs.
4
Timer time display
Time of the timer is displayed.
(When a trouble occurs, the check code is dis-
played.)
5
Timer SETIN setup display
When pushing the Timer SETIN button, the
display of the timer is selected in order of [OFF]
→ [OFF] repeat OFF timer → [ON]
→ No display.
6
Filter display
If "FILTER " is displayed, clean the air filter.
7
TEST run display
Displayed during a test run.
8
Flap position display
(for 4-Way Air Discharge Cassette Type and
Under Ceiling Type model only)
Displays flap position.
9
SWING display
Displayed during up/down movement of the flap.
10
Set up temperature display
The selected set up temp. is displayed.
11
Remote controller sensor display
Displayed while the sensor of the remote
controller is used.
7 8 9
SET DATA
SETTING TEST
UNIT No.
R.C. No.
H
12
PRE-HEAT display
Displayed when the heating operation starts or
defrost operation is carried out.
While this indication is displayed, the indoor fan
stops or the mode enters in LOW.
13
Operation ready display
Displayed when cooling or heating operation is
impossible because the outdoor temperature goes
out of the operable range.
14
No function display
Displayed if there is no function even if the button is
pushed.
15
Air volume select display
The selected air volume mode is displayed.
(AUTO)
(MED.)
In the Concealed Duct High Static Pressure type
models, [HIGH] only is displayed for the air speed.
16
Mode select control display
Displayed when pushing "Operation mode select
heating or cooling by the system manager of the air
conditioner.
17
Central control display
Displayed when using the remote controller to-
gether with the central control remote controller,
etc.
If Remote controller is prohibited at the
centralcontrol side,
the change is not accepted.
(The contents available to be set up on the remote
controller differ according to the central control
mode. For details, refer to Owner's Manual of the
central control remote controller.)
11
SET DATA SETTING TEST
H
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
CODE No.
10
11
12 14
(HIGH)
(LOW)
" button while the operation mode is fixed to
flashes when operating
ON / OFF
MODE
, , /
CODE No.
Display
UNIT No.
section
R.C. No.
ON / OFF
FAN MODE
Operation
section
SWING/FIX VENT
UNIT
17
16
13
buttons and