Toshiba MMD-AP0071SH-C Service Manual page 21

3
SELECTION OF INSTALLATION PLACE
Installation space
Reserve space required for maintenance the indoor unit and service work.
Air outlet
100 or more
<Under air inlet>
5 or more
235
210
or more
Air inlet
Ceiling
50 or more
2500 or more
Floor surface
Service space
Air outlet
50 50
Ceiling
945
Service door (Ceiling opening)
645
945
Service door (Ceiling opening)
745
945
5 or more
235 or more
210
250
or more
(Unit : mm)
<Back air inlet>
5 or more
Air inlet 210
Ceiling
300 or more
2500 or more
Floor surface
645
645
Air filter
745
Arranging the to back air inlet type
235
or more
Main unit Air filter
Air filter
Force
Remove the filter from the main unit while
pushing down on the tabs.
Notification of filter cleaning term setup
The lighting term setup of the filter sign (Notification of filter cleaning) of the remote controller can be changed
according to the condition of installation.
For setup method, refer to "Change of lighting term of filter sign" and "To secure better effect of heating" in the
Applicable controls of this Manual.
In case of wireless type
The sensor of indoor unit with wireless remote
controller can receive a signal 8m or less.
Based upon it, determine a place where the remote
controller is operated and the installation place of the
indoor unit.
• To prevent a malfunction, select a place where is not
influenced by a florescent light or direct sunlight.
• Two or more (Up to 6 units) indoor units with
wireless remote controller can be installed in the
same room.
<Back air inlet>
Main unit
(after remover)
Remove the cover plate
and then fix it to the
bottom surface.
Do surely hooking
to the main unit.