Detachments - Toshiba MMD-AP0071SH-C Service Manual

10. DETACHMENTS

No. Part name

Air Filter only for
MMD-AP0071SPH
to AP0181SPH
MMD-0071SPH-K
to AP0181SPH-K
‚
Plate inlet-A
Plate inlet-B
Procedure
REQUIREMENT
Be sure to put on gloves at working;
otherwise an injury may be caused by
parts, etc.
• Before replacement of the parts, be sure to
stop operation of the air conditioner and
turn off switch of the breaker.
1. Detachment
1) Push knobs (3 positions) of the air filter
hooks toward the arrow direction to
remove the air filter.
2. Attachment
1) Insert the air filter surely into the
hooking grooves (4 positions) at the
opposite side of the hooks, and then fix
it to the original position.
NOTE)
In case of sucking system from bottom side,
installation direction is determined. Install the
air filter so that hooks are aligned at dis-
charge side.
1. Detachment
1) Take off fixing screws while holding the
plate inlet-A with hands to remove it.
(Sucking system from rear side:
Ø4 × 10, 8 pcs)
(Sucking system from bottom side: Ø4
× 10, 11 pcs)
2) Take off fixing screws while holding the
plate inlet-B with hands to remove it.
(Ø4 × 10, 6 pcs)
NOTE)
Be careful that sheeting metal does not fall
when removing the plate inlet.
2. Attachment
1) Using the screws taken off in procedure
‚
1. 2) of , attach the plate inlets in
order of B → A while holding them not
to fall down.
[In case of sucking system from rear side]
Hook Hook Hook
[In case of sucking system from bottom side]
Air filter Air filter Air filter
Hook Hook Hook
[In case of sucking system from rear side]
Plate inlet-A: 8 screws Plate inlet-A: 8 screws Plate inlet-A: 8 screws
[In case of sucking system from bottom side]
Plate inlet-B: 6 screws Plate inlet-B: 6 screws Plate inlet-B: 6 screws
118
Remarks
Air filter Air filter Air filter
Push Push Push
Push Push Push
Plate inlet-B: 6 screws Plate inlet-B: 6 screws Plate inlet-B: 6 screws
Plate inlet-A: 11 screws Plate inlet-A: 11 screws Plate inlet-A: 11 screws