Necessary tools
•
Philips screwdriver Ph2
•
Torx screwdriver T20
•
Extended Allen key (hexagonal key) 1.5 mm
•
Extended Allen key (hexagonal key) 1.0 mm
•
Allen key (hexagonal key) 1.5 mm
•
Allen key (hexagonal key) 1.0 mm
•
Allen key (hexagonal key) 2.5 mm (2x)
How to adjust the convergence?
1. Remove the following parts (see concerning chapters):
-
cable basket
-
rear cover
-
top cover
-
engine fan cover 1
-
engine fan cover 2
2. Switch on the convergence pattern: red on blue
Image 3-87
Convergence pattern: red on blue
3. Release the four securing screws of the red formatter board
4
3
Image 3-88
Securing screws of the formatter support plate
4. Adjust the convergence of the red channel by changing the position of the red formatter in small steps
-
first adjust the convergence in the center of the image by moving in the diagonal direction
-
then adjust the rotation in two steps
first concentrate on the left center and the right center of the image
o
then concentrate on the top center and the bottom center of the image
o
Repeat the actions of this step, until the convergence is within the specification
R59770591 ENGINE KIT 26/08/2010
1
2
3. Engine replacement
43