Engine Controller Frame Assembly: Fixing Screws; Installing The Engine Fan Cover 2 - Barco Galaxy NH-12 Installation Manual

3. Engine replacement
Image 3-35
Engine controller frame assembly: fixing screws
3. Make the connections to the engine controller
- J1: from the infitec sensor
- J2: from the infitec slide
- J4: Infitec sync from connector J14 on the PMP
- J5: I2C from connector J22 on the PMP
- J7: from the infitec SW
- J10: to the infitec motor
- J30: from DMD temperature switch
- J101: power and pulses from fan LPS vertical
- J102: power and pulses from fan LPS top
- J104: power to the cooling pump
- J110: fan supply to connector J515 on the X-fan supply
- J120: fan pulses towards the power box
- J130: +12V from connector 1 on the power box
- J220: from the lens shift safety switch
- J230: signals from the CLO/LFR sensor
- J400: to the LFR light feedback board
- J402: I2C to the LPS
- J403: data from connector J2 on the lamp info receiver
4. Plug in the fan cold mirror connector: J512 on the X-fan supply
3.3.4

Installing the engine fan cover 2

Necessary tools
Torx screwdriver T20
How to install the engine fan cover 2?
1. Put the engine fan cover 2 in its correct position
Caution: Be careful not to disconnect any of the connectors of the black wires while installing this cover.
2. Fix the engine fan cover 2 using four fixing screws
22 R59770591 ENGINE KIT 26/08/2010