3.3.1
Installing the new engine
How to install the engine?
1. Plug in the additional power wires to each of the formatter boards if these are present
Image 3-25
R:
power cable connected to the Red formatter board
G:
power cable connected to the Green formatter board
B:
power cable connected to the Blue formatter board
2. Gently put the engine in the projector and align it using the alignment pins located next to the fixing screws
Image 3-26
Engine: alignment pin 1
Note: Alignment pin 2 is located next to fixing screw 2.
R59770591 ENGINE KIT 26/08/2010
3. Engine replacement
17