Intermec PC4 Programmer's Reference Manual page 63

ESim for the PC4 and PF8 Printers Programmer's Reference Manual
b - EAN/UCC Command Parameter Description (continued)
Parameter Description
F Restrain control filter, to reduce input data
information, by deleting special characters for
the bar code rendering, but let them be a part of
human readable text. Deleted characters are ( )
space CR and LF. Filters only hex 0ah, 0dh, 20h,
28h, 29h.
Default is no F.
M Manually controlled Pipe character:
Separator between data of linear and
two-dimensional composite part. Use this
parameter only in exceptional case.
Limit is any printable character.
Default is M|.
Data |Data The data area represents a string data field
1 2
surrounded by quotation-marks. Max data
length is relative chosen model type and data
mode. Invocation code in string follows the rules
for selectable Code 128, see
Codes" on page
are not allowed in composite code.
Data String of primary data to linear component.
1
Limit is 48 digit maximum.
| Data separator pipe character.
Data string of secondary data to two-dimensional
2
composite data.
Limit is all characters are in ISO 646.
Errors occur if:
• data is not suitable to optional parameters => error 01
(syntax error).
• data is too long or out of range => error 03
(at length error).
• data does not fit in area specified => error 50.
Chapter 4 — ESim Commands
"B - Standard Bar
40. FNC2, FNC3, and FNC4
49