Intermec PC4 Programmer's Reference Manual page 125

Remarks: Changing the print speed can affect the blackness of the printout,
ESim for the PC4 and PF8 Printers Programmer's Reference Manual
S Command Parameter Descriptions (continued)
Parameter Description
2 = 50 mm/sec (2 in/sec). Available for both 203.2
3 = 75 mm/sec (3 in/sec). Available for 203.2 dpi (8
4 = 100 mm/sec (4 in/
sec).
which may have to be adjusted using a D command. The density
settings has priority over speed selection, which might cause the speed
to be reduced at high density settings.
Example:
This example shows how to set the print speed to 500 mm/sec
(2 in/sec).
S2
Chapter 4 — ESim Commands
Notes
dpi and 300 dpi
printheads.
dots/mm) printheads
only.
Available for 203.2 dpi (8
dots/mm) printheads
only.
111