Toshiba RAV-SM560AT-E Service Manual page 105

Toshiban lämmitys- ja jäähdytyslaitteiden jälleenmyyjä pääkaupunkiseudulla on Jäähdytinpalvelu RefGroup Oy
13-3. Address Setup
In case that addresses of the indoor units will be determined prior to piping work after cabling work
(Manual setting from remote controller)
<Address setup procedure>
• Set an indoor unit per a remote controller.
• Turn on power supply.
1
Push + + buttons simultaneously
SET
for 4 seconds or more.
2
(← ← ← ← ← Line address) Using the temperature setup
/ buttons, set
3
Using timer time
4
Push button. (OK when display goes on.)
SET
5
(← ← ← ← ← Indoor unit address) Using the temperature setup
/ buttons, set
6
Using timer time
7
Push button. (OK when display goes on.)
SET
8
(← ← ← ← ← Group address) Using the temperature setup
/ buttons, set
9
Using timer time
0001
to Master unit, and
10
Push button. (OK when display goes on.)
SET
11
Push button.
Setup completes.
(The status returns to the usual stop status.)
3, 6, 9
END
1
<Operation procedure>
1 2
12
to the item code.
/ buttons, set the line address.
13
to the item code.
/ buttons, set 1 to the line address.
14
to the item code.
0000
/ buttons, set to Individual,
0002
to sub unit.
11
4, 7, 10
3 4 5
www.ilmalämpöpumput.com
(Example of 2-lines cabling)
(Real line: Cabling, Broken line: Refrigerant pipe)
Indoor unit address
For the above example, perform setting by connecting
singly the wired remote controller without remote
controller inter-unit cable.
Group address
Individual
Master unit : 0001
Sub unit
SET DATA
UNIT No.
R.C. No.
UNIT
SET CL
6 7 8 9
– 105 –
OUT
IN
2
Line address 1
1
1
2
Group address 1
: 0000
In case of group control
: 0002
2, 5, 8
10 11
END
OUT
IN