5.2
DIGITAL OPERATOR MODE SELECTION
The digital operator of the VS−616G5 has the following four modes.
Table 14
Programming
Auto−tuning
Modified Constants
Depressing the [MENU] key displays "Operation". Change the mode display by using
key and select a mode by the [DATA/ENTER] key. Table 15 shows typical operation.
Digital Operator Modes
Mode
Inverter operation is enabled. Displays monitor value, fault trace or faults that occurred
Opetation
previously.
Sets and reads language displayed on the digital operator, level to set/read constants and
Initialize
control method.
Sets/reads constants.
Motor−related constants necessary for vector control are automatically set. This mode is
not displayed at V/f control or V/f control with PG feedback.
Sets/reads constants changed from the values preset at the factory in programming mode or
auto−tuning mode. The constants changed in initialize mode are not displayed.
5
SETTING OPERATION CONDITIONS
Description
or
45