3
WIRING
S Only commence wiring after verifying that the power supply is turned OFF.
Failure to observe this warning can result in an electrical shock or a fire.
S Wiring should be performed only by qualified personnel.
Failure to observe this warning can result in an electrical shock or a fire.
S When wiring the emergency stop circuit, check the wiring thoroughly before operation.
Failure to observe this warning can result in personal injury.
S Verify that the inverter rated voltage coincides with the AC power supply voltage.
Failure to observe this caution can result in personal injury or a fire.
S Do not perform a withstand voltage test of the inverter.
It may cause semi−conductor elements to be damaged.
S To connect a braking resistor, braking resistor unit or braking unit, follow the procedures
described in APPENDIX 3.
Improper connection may cause a fire.
S Tighten terminal screws to the specified tightening torque.
Failure to observe this caution can result in a fire.
This chapter describes the main circuit wiring and the control circuit wiring of the VS−616G5.
WARNING
CAUTION
3
WIRING
17