Configuring Basic Port Settings - Cisco 220 Series Smart Plus Administration Manual

Port Management

Configuring Basic Port Settings

STEP 5
STEP 6
STEP 7
Configuring Basic Port Settings
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
Configure the LACP parameters for the ports that are members or candidates of a
dynamic LAG on the LACP page, as described in the
Configure 802.3 Energy Efficient Ethernet per port on the Energy Efficient Ethernet
> Port Settings page, as described in the
section.
If PoE is supported and enabled for the switch, configure the switch as described
in the Power-over-Ethernet
Use the Port Settings page to see and modify the global and per port setting of all
the ports.
SFP fiber takes precedence when both ports are being used.
To configure port settings:
Click Port Management > Port Settings.
Check Enable beside the Jumbo Frames field to support packets of up to 10,000
bytes in size. If Jumbo Frames is not enabled (default), the switch supports packet
size up to 1522 bytes.
Click Apply. The global port setting is defined, and the Running Configuration is
updated.
To update the settings of a port, select the desired port and click Edit.
Modify the following parameters:
• Interface—Select the port to be modified.
• Port Description—Enter the port user-defined name or comment.
• Port Type—Displays the port type.
• Administrative Status—Select whether the port should be operational (Up)
or non-operational (Down) when the switch is rebooted.
• Operational Status—Displays the current port connection status.
Configuring Energy Efficient Ethernet
chapter.
Configuring LACP section.
9
101