Table of Contents
Advertisement
Multicast Forwarding
Configuring Maximum IGMP and MLD Groups
STEP 1
STEP 2
STEP 3
STEP 4
Configuring Maximum IGMP and MLD Groups
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
To define Forward All Multicast:
Click Multicast > Forward All.
Define the VLAN ID, IP version, and port type for which Multicast traffic comes
from, and click Go.
Select the interface that is to be defined as Forward All by using the following
methods:
•
Static—The port receives all registered Multicast streams.
•
Forbidden—The port cannot receive any registered Multicast streams, even
if IGMP/MLD snooping designated the port to join a Multicast group.
•
None—The port is not currently a Forward All port.
Click Apply. The Running Configuration is updated.
Use the Maximum Multicast Groups page to configure the maximum number of
Multicast groups that are allowed on each interface and specify the action when
reaches the limit.
To define the maximum number of IGMP and MLD groups on an interface:
Click Multicast > Maximum Multicast Groups.
Select the port type (Port and LAG), and click Go.
Select an interface and click Edit.
Enter the following information:
•
Interface—Select the interface to which the maximum multicast groups
settings are applied.
•
IGMP Maximum Multicast Group—Enter the maximum number of IGMP
groups that are allowed on the interface.
•
IGMP Exceed Action—Denies or replaces the existing group with the new
group for which the IGMP report was recevied when the limit is reached.
14
169
Advertisement
Table of Contents
