Configuring Basic Routing Settings; Configuring Routing Mode; Configuring Inter-Vlan Routing; Configuring Static Routing - Cisco RV315W Administration Manual

Networking
Configuring Routing
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco RV315W Broadband Wireless VPN Router Administration Guide

Configuring Basic Routing Settings

Depending on the requirements of your ISP, you can configure the RV315W to
operate in NAT mode or Routing mode. By default, NAT mode is enabled.

Configuring Routing Mode

To configure the routing mode:
Click Networking > Routing > Basic Routing. The Basic Routing page opens.
In the Routing Mode area, configure the routing mode between WAN and LAN.
• If your ISP assigns an IP address for each of the computers that you use, click
Routing to enable the Routing mode.
• If you are sharing IP addresses across several devices such as your LAN and
using other dedicated devices for the DMZ, click Gateway to enable the
Gateway mode.
Click OK to save your settings.

Configuring Inter-VLAN Routing

To configure inter-VLAN routing:
Click Networking > Routing > Basic Routing. The Basic Routing page opens.
In the Inter-VLAN Routing area, check Enable to enable inter-VLAN routing.
Click OK to save your settings.

Configuring Static Routing

To configure static routes, specify the IP address and related information for the
destination.
Click Networking > Routing > Basic Routing. The Basic Routing page opens.
In the Static Route area, click Add to add a new static route.
Enter the following information:
5
61