Configuring Basic Wireless Settings - Cisco RV215W Administration Manual

Configuring the Wireless Network

Configuring Basic Wireless Settings

Configuring Basic Wireless Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Draft Version 1—Cisco Confidential
You can use the Basic Settings page (Wireless > Basic Settings) to configure
basic wireless settings.
To configure basic wireless settings:
Choose Wireless > Basic Settings.
In the Radio field, check Enable to turn on the wireless radio. By default there is
only one wireless network enabled, ciscosb1.
In the Wireless Network Mode field, choose one of these options from the
drop-down menu:
B/G/N-Mixed
B Only
G Only
N Only
B/G-Mixed
G/N-Mixed
If you chose B/G/N-Mixed, N-Only, or G/N Mixed, in the Wireless Band Selection
field, select the wireless bandwidth on your network (20MHz or 20/40MHz). If
you chose N-Only, you must use WPA2 security on your network. See
the Security Mode.
In the Wireless Channel field, choose the wireless channel from the drop-down
menu.
In the AP Management VLAN field, choose VLAN 1 if you are using the default
settings.
Choose this option if you have Wireless-N,
Wireless-B, and Wireless-G devices in your
network. This is the default setting (recommended).
Choose this option if you have only Wireless-B
devices in your network.
Choose this option if you have only Wireless-G
devices in your network.
Choose this option if you have only Wireless-N
devices in your network.
Choose this option if you have Wireless-B and
Wireless-G devices in your network.
Choose this option if you have Wireless-G and
Wireless-N devices in your network.
3
Configuring
57