Seatrial And Calibration; Depth Offset - Raymarine Remote display Owner's Manual

4

Seatrial and Calibration

Once the Micronet system has been installed on the vessel and Auto
Networking has been completed it is necessary to carry out Calibration.
It is not safe to use the displays for navigational purposes until
Calibration has been carried out correctly.
4.1

Depth Offset

The default depth offset is 0.0 making the display read the depth below
the transducer. By adding a +ve or -ve offset the display will show the
waterline depth or depth below the keel respectively.
To enter a depth offset:
Press and hold the
Press the
Press the
Press the
Press the
Press and hold the
operation.
www.raymarine.com
button for 2 seconds to enter Setup.
button repeatedly to scroll to the Sensors chapter.
button to enter the sensors menu.
button repeatedly to scroll to the Depth page.
button to advance to the Keel/Waterline Offset parameter.
Press the
value will flash.
Press the and
Press the button to exit Edit Mode.
button to exit Setup and return to normal
button to enter Edit Mode, the parameter
buttons to change the value.
Seatrial and Calibration
31