S39
Boat Show (Demonstration Mode)
S40
Factory Reset
S41
Software Version/Network Nodes
The top line of each Health chapter screen shows the software version
of the Remote Display, battery level and charge rate to assist in
troubleshooting and fault finding.
S42
Hull Transmitter Signal Strength
S43
Wind Transmitter Signal Strength
S44
Wireless (NMEA) Interface Signal Strength
www.raymarine.com
Allows the display to show information when NOT installed as
part of a Micronet system for demonstration purposes only.
Displays will return to default Off on power down.
Returns all the calibration setting to the factory default values.
Health Chapter
If the display is the "Master" (the one used to switch on the
system) then the number of items (nodes) in the system will
be shown.
If the display is a "Slave" (was switched on by the system)
then the signal strength to the "Master" will be shown in place
of the number of nodes.
Shows the signal strength, software version, battery level and
charge rate of the Hull Transmitter to assist in trouble
shooting and fault finding.
As above but for Wind Transmitter information.
As above but for Wireless (NMEA) Interface information.
Setup and Calibration
29