Raymarine Remote display Owner's Manual page 29

Remote Chapter
S31 Remote Mode
S32 Modify Control List
network are shown on the list of controllable displays when the
button is pressed. By default all other displays on the network are
hidden from the list.
To modify the list of controllable displays:
Press the
A list of all displays currently connected to the network is shown.
Individual displays are identified by a numeric display ID (starting at :01)
and are marked as follows:
SHOW - the display will be visible in the list of available displays.
HIDE - the display is connected to the Micronet network, is compatible
with remote control, but will not be shown on the list of controllable
displays.
N.C. - (Non Controllable) the display is connected to the Micronet
network but is not compatible with remote control (i.e. it has an older
version of the software). This display will not be shown in the list of
controllable displays.
WAIT - the system is building the list of connected displays.
To add or remove a display from the list of controllable displays:
Press the
the display in the list of controllable displays is shown by the
Press the
Press
Press
www.raymarine.com
Permits the remote control function to be enabled or
disabled. Press the
OFF.
The Remote Display builds a list of the Micronet displays on
the network that are configured for remote control. This list
allows the user to select a display to control with the Remote
Display. By default, all Maxi and Dual Maxi displays on the
button to enter list configuration mode.
button to scroll down the list. The sequence number of
button , the selected display entry will flash.
or to toggle between SHOW and HIDE.
to confirm the change.
Setup and Calibration
button to toggle between ON and
cursor.
27