Raymarine Remote display Owner's Manual page 17

25 TTG (Time to go to waypoint)
26 SEA (Sea temperature)
27 RACE TIMER
Press and hold for 1 second the
Use the
minutes.
Press the
To operate the timer:
Press the
The display will sound a single beep every 60 seconds until 1 minute
remains when a beep will sound at 10 second intervals. The final 10
seconds will count down with a beep each second with "START" being
indicated by a triple quick beep at 0 seconds.
At any time during the countdown a quick press of the
re-synchronise the timer to the nearest minute and commence
countdown from that point.
After the countdown is completed, the timer will automatically start to
count the elapsed time and this will continue until the
pressed and held for 2 seconds.
www.raymarine.com
The calculated time remaining before you will arrive at the
(active) waypoint as calculated by a GPS receiver or plotter.
Current sea temperature as measured by the sensor in the
Speed Transducer.
Displayed in the current temperature units.
See p 23 S13 to select units.
Countdown and elapsed time clock.
The timer can only be set and operated in single item display
mode. In 4 line display mode the current state of the count
down or elapsed time can be viewed but not modified.
To set the countdown period:
and buttons to set the required countdown time in
button quickly to prepare to start the countdown.
button quickly to start the countdown.
button.
Operation
button will
button is
15