Raymarine Remote display Owner's Manual page 15

To manually overide this automatic calculation and set the mean wind
direction:
1. If a Wind Transmitter is included in your Micronet system then simply
press the
mean wind direction and displayed for 5 seconds during which time
the
If the mean wind direction changes, press
2. If you do not have a Wind Transmitter included, sail close hauled and
press the
If the mean wind direction changes then the display may be updated
by pressing and holding the
the
while head to wind.
See Raymarine's "Using wind shifts to your advantage" sheet for further
information, this is available on the Raymarine web site,
www.raymarine.com.
depending on the current compass setting.
See page 24 S24 to set.
www.raymarine.com
button; (the current wind direction is stored as the
and buttons may be used to adjust the value.)
button then tack and, once close hauled, press the
button again.
button while sailing on starboard tack or the
16 HEADING
Current magnetic compass heading of the vessel as
measured by the Compass Transducer.
The value displayed will be affected by the calibration routine
for the compass (see page 34).
The heading is displayed as degrees Magnetic or True
17 TACKHDG (Heading on opposite tack)
Magnetic compass heading that the vessel will follow should
it tack through the wind, calculated by the display. Apparent
Wind Angle and Magnetic Heading must be available for this
calculation to be made.
18 SOG (Speed over the ground)
The vessel's speed over the ground as calculated by the
GPS Antenna or a GPS receiver.
again.
button while sailing on port tack,
Operation
button
13