Table of Contents
Advertisement
10
MEMORY OPERATION
I Memory description
The IC-M801GMDSS has several kinds of memories
as follows:
• Address and group ID code memories (p. 43)
• Call, traffic and scan frequency memories (p. 44)
• DSC transmission memory (described in this section)
• Received message memory (p. 31)
I Memory writing
q During DSC watch mode, select the desired format
category (except distress and test), and set the
message, traffic and call frequencies until the call
stand-by screen is displayed as described in the
CALL PROCEDURE section (pgs. 20–28).
w Push and hold [ENT] for 1 sec. to select the TX
memory write condition.
e Rotate [CH] to select the desired memory channel.
- - - T X m e m o r y w r i t e - - - -
Ç
0 :
1 :
2 :
3 :
4 :
5 :
S E L
I Memory reading/transmitting/deleting
q Push [DSC] to select DSC watch mode, if neces-
sary.
w Push [TX
] to enter the DSC transmit memory
TXF
screen.
• Or, push [MODE
memory" then push [ENT], also selects the transmit
memory screen.
e Rotate [CH] to select the selected memory chan-
nel to be read.
* * * * * * T X m e m o r y * * * * * * *
- - - - - - - - S e l e c t - - - - - - - -
Ç
0 : I n d i v i d u a l 9 8 7 6 5 4 3 2 1
1 :
2 :
3 :
4 :
5 :
S E L
42
W r i t e
], rotate [CH] to select "TX
SET
O K
10 DSC transmission memory channels allow you to
set often used format specifiers and contents such as
for routine calls, group calls, etc.
r Push and hold [ENT] for 1 sec. again to store the
condition into the selected memory channel.
• The set DSC format and calling station ID/name ap-
pear.
- - - T X m e m o r y w r i t e - - - -
Ç
0 : I n d i v i d u a l 9 8 7 6 5 4 3 2 1
1 :
2 :
3 :
4 :
5 :
S E L
O K
t Push [ENT] to return to the calling stand-by condi-
tion, or push [MODE
SET
mode.
r Push [ENT] to display the memory contents.
* * * * * * T X m e m o r y * * * * * * *
- - - - - - I n d i v i d u a l - - - - - -
T o : 9 8 7 6 5 4 3 2 1
C a t e g o r y : R o u t i n e
T r a f f i c : J 3 E
T X
R X
C a l l F r e q : T X
R X
C a l l
t Operate as follows:
➥ When reading the memory contents only;
• Push [MODE
] to return to DSC watch
SET
mode.
➥ When transmitting the memory contents;
• Push and hold [CALL] for 1 sec.
➥ When clearing the memory contents;
• Push and hold [CE] for 1 sec.
] to return to DSC watch
2 1 3 4 . 0 k H z
2 1 3 4 . 0 k H z
2 1 8 7 . 5 k H z
2 1 8 7 . 5 k H z
D E L
Advertisement
Table of Contents
