Memory Operation; About The Memory Channels; Selecting Memory Channels - Icom IC-7200 Instruction Manual

4

MEMORY OPERATION

■

About the Memory channels

The transceiver has 201 memory channels, including 2 scan
edge channels.
The Memory mode is very useful to quickly select often-used
frequencies.
MEMORY
CHANNEL
Regular memory
channels
Scan edge
memory channels
■

Selecting Memory channels

V/M
q
Push to select the Memory mode.
• "
" appears.
w
Rotate [M-CH] to select the desired memory channel.
• If the RIT control indicator is bright orange, push
M-CH/RIT
to turn OFF the RIT and set the [M-CH] con-
SET
trol to memory channel control. (See details below.)
• All memory channels, including blank channels, can be
selected.
• Pushing [UP]/[DN] on the microphone also selects the
memory channels. Only programmed memory chan-
nels are selectable using the microphone buttons.
Lower channels
About the [M-CH] control:
When the RIT control indicator lights orange, the mem-
ory channels cannot be selected
control because the [M-CH] control acts as the RIT con-
M-CH/RIT
trol. Push
SET
channel control (RIT control indicator goes out).
21
MEMORY
CHANNEL
NUMBER
Independent transmit and receive frequencies
1–199
and mode in each memory channel.
One frequency and one mode in each memory
P1, P2
channel to use as scan edges for a programmed
scan.
RIT control indicator
goes out
Higher channels
by rotating the
to set the [M-CH] control to memory
All 201 memory channels are tunable, which means the pro-
grammed frequency can be tuned temporarily by rotating
[DIAL], even, in the memory mode.
CAPABILITY
[EXAMPLE]: Selecting memory channel 17.
VFO mode
Memory mode
[M-CH]
Channel 17 is selected.
COPY OVER-
CLEAR
TO VFO WRITING
Yes Yes
Yes Yes
RIT control
indicator
ANF
NB NR
METER
1 2 3
V/M A/B
SPLIT
=
1.8 3.5 7
4 5 6
MW M-CL AGC
10 14 18
7 8 9
COMP SCAN VOX
21 24 28
.
MODE TS 0
F-INP ENT
RIT MNF
GENE 50
BAND
TUNER FILTER
P.AMP
ATT
M-CH/RIT
SPCH
SET
[M-CH]
Push
Appears
Rotate [M-CH]
Yes
No