Memory Operation; General Description; Memory Channel Selection - Icom ID-800H Instruction Manual

■ General description

The transceiver has 512 memory channels including 10 scan
edge memory channels (5 pairs), and 2 call channels. Each of
these channels can be individually programmed with operat-
ing frequency (pgs. 11, 12), duplex direction (p. 21) and off-
set (p. 24), subaudible tone encoder or tone squelch and its
tone frequency (pgs. 20, 22, 52, 53) and skip information*
(p. 44).
In addition, a total of 10 memory banks, A to J, are available
for usage by group, etc.
*except for scan edge memory channels.

■ Memory channel selection

D Using the tuning dial
q Push [M/CALL•PRIO] several times to select memory
mode.
• "!" indicator appears
[M/CALL•PRIO]
w Rotate [DIAL] to select the desired memory channel.
• Programmed memory channels only can be selected.

MEMORY OPERATION

D Using the [Y]/[Z] keys
MR/CALL
D Using the keypad
MR/CALL
"!" appears
z Push [MR/CALL] to select memory mode.
x Push [Y] or [Z] to select and set the desired
memory channel.
• Pushing [Y]/[Z] for 1 sec. activates a scan.
Y/Z
• If scan is activated, push [Y]/[Z] again or push
[ A(MW)] to stop it.
CLR
z Push [MR/CALL] to select memory mode.
x Push [
C(T-OFF)] to activate the keypad
ENT
for numeral input.
c Push 3 appropriate digit keys to input a chan-
nel number.
• Blank channel can be selected.
• Push only 1 appropriate digit key, [
[ 2(T-SCAN)],
SCAN
[ 4(DTCS)] or [
HIGH
[M M (TONE-1)] or [
SQL
edge channels. "M M " and "#" can be used for "A"
and "b" respectively.
5
1(BANK)],
MONI
[ 3(PTT-M)],
PRIO
5(DTCSS)] then push
MID
#(16KEY-L)] to select scan
Z
4
5
26