Display Assembly - HP ZBook 15 G2 Mobile Workstation Maintenance And Service Manual

Display assembly

NOTE: The DreamVision display assembly is spared as a whole unit assembly only. The LED display
assembly is spared at the subcomponent level only. For more LED display assembly spare part information,
see the individual removal subsections.
Description
15.6-in, FHD, UWVA, DreamVision display assembly equipped with a webcamera
15.6-in, FHD, UWVA, DreamVision display assembly not equipped with a webcamera
To remove the display assembly and access the LED display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. Keyboard (see
e. Top cover (see
Remove the display assembly:
1. Close the computer.
2. Turn the computer upside down, with the rear toward you.
3. Make sure that the WWAN antenna cables are disconnected from the WWAN module (see
on page
4. Make sure that the WLAN antenna cables are disconnected from the WLAN module (see
on page
Battery on page
Service cover on page
Hard drive on page
Optical drive on page
Keyboard on page
Top cover on page
50).
53).
44), and then remove the following components:
45)
46)
48)
57)
65)
Spare part number
735965-001
735964-001
WLAN module
Component replacement procedures
WWAN module
87