HP ZBook 15 G2 Mobile Workstation Maintenance And Service Manual page 67

4. Insert a thin tool into the keyboard release hole in the optical drive bay, and then press on the back of
the keyboard until the keyboard disengages from the computer.
5. Turn the computer right-side up, with the front toward you.
6. Open the computer as far as it will open.
7. Lift the rear edge of the keyboard until it rests at an angle.
8. Swing the rear edge of the keyboard (1) up and forward until it rests upside down on the palm rest.
9. Release the zero insertion force (ZIF) connector (2) to which the keyboard cable is attached, and then
disconnect the keyboard cable from the system board.
10. Release the ZIF connector (3) to which the pointing stick cable is attached, and then disconnect the
pointing stick cable from the system board.
Component replacement procedures 59