Smart Card Reader - HP ZBook 15 G2 Mobile Workstation Maintenance And Service Manual

Smart card reader

Description
Smart card reader (includes cable)
Before removing the smart card reader, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. Keyboard (see
e. Top cover (see
f. ExpressCard assembly (see
Remove the smart card reader:
1. Release the ZIF connector (1) to which the smart card reader cable is attached, and then disconnect the
smart card reader cable from the system board.
2. Remove the two Torx T8M2.5×4.5 screws (2) that secure the smart card reader to the base enclosure.
3. Remove the smart card reader (3).
76 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 44), and then remove the following components:
Service cover on page
Hard drive on page 46)
Optical drive on page 48)
Keyboard on page 57)
Top cover on page 65)
ExpressCard assembly on page
45)
74)
Spare part number
742159-001