Service Cover - HP ZBook 15 G2 Mobile Workstation Maintenance And Service Manual

Service cover

Description
Service cover
Before removing the service cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Remove the service cover:
1. Slide the service cover release latch to the left (1), and then remove the optional Phillips PM2.0×4.5
screw (if the screw is being used) (2).
NOTE:
2. Slide the release latch again (3) to release the service cover.
3. Slide the service cover toward the front of the computer (4), and then lift to remove the service cover
(5).
Reverse this procedure to install the service cover.
Battery on page
If you want to use the optional screw, it is stored inside the service cover.
44).
Component replacement procedures
Spare part number
734278-001
45