Elation FOCUS SPOT 250 Manual page 7

Hide thumbs Also See for FOCUS SPOT 250:

Table of Contents

Features

Pan 630° / Tilt 265°

17° Beam Angle

8 Dichroic color plus spot, for a total of 9 colors

7 Rotating Gobos

Strobe: 0~10Hz

Electronic Focus via DMX

Sound Active – Master/Slave Operation

4 Segment Digital LED

High speed pan & tilt movements

Reversible Display (Can be turned 180°)

Bright MSD 250 Discharge Lamp

Lamp switches ON/OFF locally

Glass Dischoric Reflector for Even Lamp Dispersement

Switchable Power Supply (Internal)

Internal Program:

edit and save programs to the incorporated EEPROM through the front control panel or

external controller; you can save a maximum of 48 scenes, and run the saved programs

by using the "run" menu on the front control panel

This device falls under protection-class I. Therefore it is essential that the device be

grounded properly.

All electrical connections must carried out by qualified person.

Be sure the available voltage matches the voltage requirements of the unit..

Be sure the power cord is never crimped or damaged. If the power cord is damaged, replace

it immediately with a new one of similar power rating.

Always disconnect from the mains, when the device is not in use or before performing any

service or cleaning procedure.

Only handle the power cord by the plug. Never pull out the plug by tugging the wire portion of

the cord.

During initial start-up some smoke or smell may arise. This is a normal process and does not

necessarily mean that the device is defective, it should decrease gradually over time.

–

Focus Spot 250™

Table of Contents