Elation FOCUS SPOT 250 Manual page 32

Hide thumbs Also See for FOCUS SPOT 250:

Table of Contents

SPOT – This function allows you to optimize the lamp without the use of an external

DMX controller. In this mode, the device will not react to any control signal.

1. Access the main menu.

2. Tap the UP button until

3. Tap the UP button until

4. The display will show

5. Press the UP button to display

deactivate this function.

6. Press MODE/ENTER to confirm.

7. Press EXIT to return to the main menu.

DFSE - With this function you can restore the factory settings of the device. All

settings will be set back to the default values. Any edited scenes will be lost. When

restoring the factory settings the unit must be set to the address that the unit was in

when you started editing. When you exit this function, the unit will begin to reload

data.

1. Access the main menu.

2. Tap the UP button until

3. Tap the UP button until

4. The display will show

5. Press the UP button to display

deactivate this function.

6. Press MODE/ENTER to confirm.

7. Press EXIT to return to the main menu.

VER - Use this function to display the Software version of the unit.

1. Access the main menu.

2. Tap the UP button until

3. Tap the UP button until

4. The display will show V-1.0", the display may also show, V-2.0", V-9.9 etc.

©Elation Professional®

SPEC