Elation FOCUS SPOT 250 Manual page 19

Hide thumbs Also See for FOCUS SPOT 250:

Table of Contents

Focus Spot 250™

Note:

After switching on, the Focus Spot 250™ will automatically detect whether DMX 512 data is

received or not. If the data is received, the display will show "A.XXX" (XXX representing the

actual DMX address). If the fixture is not receiving DMX signal the display will flash "A.XXX"

(XXX representing the actual DMX address). This situation can occur if:

- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input

of the machine.

- the controller is switched off or defective, if the cable or connector is defective or the signal

wires are swap in the input connector.

–

Focus Spot 250™

Table of Contents