Elation FOCUS SPOT 250 Manual page 35

8. Repeat steps 5-8, until you finish setting all the DMX values for all the channels of
this scene, each scene can have 15 channels maximum.
9. Once all the channels are completed, the display will .ash
the time needed to run this scene.
10. Press MODE/ENTER to edit the time needed, the display shows
stands for the time needed to run this scene. For example,
needs 6 seconds to run,
Note: XX is always three seconds not one second.
11. Adjust the time needed by pressing the UP button.
12. Press MODE/ENTER to save the settings for the scene you are editing, the
display will change to the next scene automatically.
13. Repeat steps 3-12 to edit other scenes, you can edit and save 48 scenes
maximum.
14. Press EXIT to exit, now you have edited and saved scenes using the control
board. The number of steps can be defined under
called up under
Editing procedure 2: Using an external controller.
1. Access the main menu.
2. Tap the UP button until
3. The display will show
For example: If
4. Change the scene number by pressing the UP button.
5. Press MODE/ENTER, the display will show
channel number 1.
6. Press the UP button until
7. The display will show
press MODE/ENTER.
8. The display shows
©Elation Professional®
T-15 means this scene needs 45 seconds to run.
Run . To run the scenes see page 26.
EDIT is displayed. Press MODE/ENTER.
SC01 , this stands for the first scene number to be edited.
SC01 is displayed, you will be editing scene 1.
CEDT
OFF , press the UP button so that
SC02 . You have successfully downloaded the .rst scene.
-
EDIT
C-01 , the
is displayed, press MODE/ENTER.
–
Focus Spot 250™
TIME , this stands for
T-XX , XX
T-02 means scene 1
and the scenes can be
1 stands for the
ON is displayed,
Focus Spot 250™