Elation FOCUS SPOT 250 Manual page 18

Hide thumbs Also See for FOCUS SPOT 250:

Table of Contents

Focus Spot 250™

Fixture DMX address;

All fixtures should be given a DMX starting address when using a DMX signal, so that the

correct fixture responds to the correct control signals. This digital starting address is the

channel number from which the fixture starts to "listen" to the digital control information sent

out from the DMX controller. The allocation of this starting address is achieved by setting the

correct number on the display located on the base of the device.

You can set the same starting address for all fixtures or a group of fixtures , or make different

address for each fixture individually.

If you set the same address, all the units will start to "listen" to the same control signal from

the same channel number. In other words, changing the settings of one channel will affect all

the fixtures simultaneously.

If you set a different address, each unit will start to "listen" to the channel number you have

set, based on the quantity of control channels of the unit. That means changing the settings

of one channel will affect only the selected fixture.

In the case of the Focus Spot 250™, which is a 11 channel fixture, you should set the

starting address of the first unit to 1, the second unit to 12 (11 + 1), the third to 23 (12 + 11),

and so on.

–

Focus Spot 250™

Table of Contents