Ektapro Model 4020 - Kodak EKTAPRO 9020/CINE Service Manual

SM 2547-1

EKTAPRO Model 4020

Adjustable Tray Motion
Manual elevator mechanism :
Indicator LED on front
Remote SOCKET
Slide change buttons
Last Lamp used
Line up
In case of using a IR Remote Control single steps are possible independent how long the button is pressed.
By pressing the "Reverse button" on the IR Remote Control random access is possible.
To select the Slide Tray capacity (80 or 140 slides) a ball point pen or a small screwdriver has to be used.
The Lamp Module has no longer a Heat Absorbing Glass installed. Due to the new mirror the light output is
In case of changing the mirror take care of the type (see NEWSLETTER #4).
Kodak AG, Stuttgart
: Tool PN 622 0454 has to used on Projectors from SN 85 xxx and
above
Two height adjustment feet are attached on the front side of the
Projector
: LED continuously on Projector O.K. If the LED is blinking fast a slide
jam occurs. In standby mode the LED is blinking short off and long on.
If the LED is blinking continuously (on/off) a checksum error occurs
(only during programming the processor)
: 8 pin mini DIN
: A single step will happen after pressing the "Forward" or the "Reverse"
button less than 0.9s. Multiple steps will be done by pressing the
"Forward" button more than 0.9s
A run into the "Zero" position will immediately be done after press and
hold the "Reverse" button until the Slide Tray is in "Zero" position
: After switching on the Projector the last used lamp will be selected
(memory function). This memory function can be disabled by pressing
the STANDBY button during switching on the projector
: Pressing both transport keys will enable the lamp to adjust the projector
(green LED on the Backpanel is blinking). The Standby key will disable
this function
NEW
increased up to 30%.
NOTE
2-3
Service Manual
03/98