Installation; Mounting And Placement - Cornelius IDC 255 PROGATE DRIVE THRU UNIT Installation Manual

IDC 255 Progate Drive Thru Installation Manual
M P
OUNTING AND
!
WARNING:
It is the responsibility of the installer to ensure that the water supply to the dispensing equipment is provided with
protection back flow by an air gap as defined in ANSI A 112.1.2-1979; or an approved vacuum breaker or other such
method as proved effective by test and must comply with all federal, state and local codes.
Failure to comply could result in serious injury, death or damage to the equipment.
Water pipe connections and fixtures directly connected to a potable water supply
maintained according to Federal, State and Local
1. Locate the dispenser indoors on a level counter top.
A. LEG OPTION
Unpack the four (4) legs and install them into the threaded holes provided at the bottom of the unit. The
installer must provide flexibility in the product and utility supply to permit shifting the position of the dis-
penser sufficiently to clean the area beneath it.
COUNTER MOUNTING
The ice drink dispenser must be sealed to the counter. The template drawing indicates where openings can be cut in
the counter. Locate the desired position for the dispenser, then mark the outline dimensions on the counter using the
template drawings. Cut openings in counter.
1 13/16
1 5/16
18 5/8
Z Style
Apply a continuous bead of
1/4-inch inside of the unit outline dimensions and around all openings. Then, position the unit on the counter within
the outline dimensions. All excess sealant must be wiped away immediately.
Publication Number: 621057419INS

INSTALLATION

LACEMENT
laws.
7/16 DIA.
30
26 3/8
12
3 1/2
9 1/2
23
REMOVABLE SINK
RECOMMENDED COUNTER OPENING SIZE
9 X 12 FOR UTILITIES AND BEVERAGE
TUBING. OPENING CAN BE LOCATED
ANYWHERE WITHIN SHADED AREA.
NSF International (NSF) silastic sealant (Dow 732 or equal) approximately
9
11
Figure 5.
- 8 -
shall be sized, installed and
21 1/4
31 1/2
30
23 1/16
© 2006-2014, Cornelius Inc.