Mazda 6 Installation Instructions Manual page 8

6．VEHICLE PART REMOVAL
CAUTION
• Be careful not to damage or lose any parts removed from the vehicle since they will be reused.
Negative battery cable
(1)
Trunk covering
Trunk board No.3
(1)
Trunk board No.1
Negative battery cable disconnection
1. Set the selector lever to P range.
• When removing/installing the parts, park the vehicle on
2. Disconnect the negative battery cable and wrap tape around it
• When the negative battery cable is connected during
Vehicle front
Trunk covering removal
1. Remove the trunk covering in the direction of arrow (1) shown
Trunk board removal
【With Temporary Spare Tire】
(3)
1. Set the trunk covering aside.
2. Remove the trunk board No.1 in the direction of the arrow (1)
(2)
3. Remove the trunk board No.2 in the direction of the arrow (2)
4. Remove the trunk board No.3 in the direction of the arrow (3)
Trunk board No.2
(AT vehicles only)
WARNING
level ground and apply the side brake securely. Be sure to
turn the ignition switch off, otherwise the vehicle can move,
causing personal injury or vehicle damage.
to insulate.
WARNING
operation, it may cause electric shock or other personal
injuries. Disconnect the negative battery cable before
removal/installation.
Tightening torque : 4.0-6.0 N･m
in the figure.
shown in the figure.
shown in the figure.
shown in the figure.
8