Mazda 6 Installation Instructions Manual page 6

4. PAINT SENSOR
Ring
Sensor
SURFACE TREATMENTT
a : Paint same as body color
b : Masking required
Spray gun
Tweezers
Sensor
1. Install the ring to the sensor.
2. Masking required (use ring to mask sensor channel)
2. Coat the sensor surface with the body color paint.
CAUTION
• Paint characteristics vary according to paint type. Check
manufacturer specifications before painting.
3. Use two-component urethane paint. (Main component: acrylic
polyol, curing agent: isocyanate)
CAUTION
• Do not use lacquer paints because their weatherproofing
and adhesion characteristics are poor.
Ring
• Maximum paint thickness: primer 30 um, paint 95 um
4. When painting, use a spray gun to apply the paint evenly.
• Paint infiltration into connector must be avoided; pin contact
must be guaranteed after painting.
• Maximum paint curing: 90 C for 1 hour.
5. After baking, do not touch the painted product until it has cooled
down completely.
• Hot storage temperature: 85 C.
6. When the painting is dried, remove the ring using tweezers.
• Be careful not to peel off the paint when removing the ring.
• Do not reuse the removed ring.
CAUTION
6