Brake/taillight connector
Grommet
Rear combination light
Grommet
Hook
Stud bolts
Rear splash shield
Cap nut C
Fastener B
Vehicle front
Rear splash shield
4. Pull the rear combination light in the direction of the arrow (1)
shown in the figure and pull out pins, stud bolts and hook from
the body.
5. Disconnect the brake/taillight connector.
6. Remove the rear combination light.
Pin
(1)
Rear splash shield removal
Fastener B
NOTE:
• The figure shows the left side, however, the procedure is
1. Remove screws A.
2. Remove fasteners B.
3. Remove the cap nut C.
4. Remove the rear splash shield.
Screw A
Screw A
Screw A
Screw A
Vehicle front
the same for the right side.
11