Harness (Long) - Mazda 6 Installation Instructions Manual

8．WIRING HARNESS
■ Harness (short and long)
OK
Cover Cover
Sensor
Harness (short)
Sensor
Electrical vinyl tape
Vehicle front
1. Connect the harness (short and long) connector to the No.1,
NG
Sensor

Harness (long)

2. Remove the electrical tape wrapped around the hole cover.
Hole Cover
3. Remove the hole cover and set it inside the vehicle using
Hole Cover
No.2, No.3, No.4 sensor.
CAUTION
• Make sure the connector is securely pressed in until a click
sound is heard.
needle-nose pliers.
16