Mazda 6 Installation Instructions Manual page 10

Trunk end trim
Pin C
(1)
Clip E
Clips B
Pin C
Pins D
Clip B Pin C Pin D
Nuts
Rear turn light
connector
Protective tape
Rear combination light
Guides F
(2)
Clip E
Clip E Guide F
4. Pull the trunk end trim in the direction of the arrow in the order
of (1), (2) shown in the figure while detaching clips B, pins C,
pins D, clips E, and guides F.
CAUTION
• When performing the procedure with a rear seat cushion
removed from the vehicle, perform the procedure on a
clean cloth so as not to damage or soil the seat.
Rear combination light removal
NOTE:
• Fogging or condensation on the inside of the rear
combination lights may occur due to a natural phenomenon
occurring as a result of a temperature difference between
the interior and exterior of the combination lights. However,
it has no effect on the light performance because the
temperature inside the rear combination lights rises after
illuminating the brake/taillight bulbs or a period of time has
elapsed.
• The figure shows the left side, however, the procedure is
the same for the right side.
1. Disconnect the rear turn light connector.
2. Remove the nuts.
Tightening torque : 4.1-6.1 N･m
3. To prevent scratches or damage, affix protective tape to the
position shown in the figure.
CAUTION
• When the rear combination light is removed from the body,
perform the procedure after affixing protective tape to the
body. Otherwise, the body could interfere with the rear
combination light and cause scratching or damage to the
body.
10