Installation - Mazda 6 Installation Instructions Manual

INSTALLATION

INSPECTION
SHEET
Perform the following inspections
WARNING
• Before starting the engine, make sure there are no persons in front of or behind the vehicle, or around the engine
compartment. Otherwise a serious accident could result by the vehicle suddenly moving.
• Do not start the engine in a place such as a garage or other location with poor air ventilation. Otherwise,
poisoning or asphyxiation could result from accumulation of exhaust gas.
• Always set the wheel blocks on level ground before performing the verification.
1. Inspection items after installation
• Verify the fitting between the vehicle part and the installed part, and inspect for damage or dirt.
•
When connecting connectors, verify the connection again to prevent poor connection or mis-connection.
(Insert two times.)
2. Vehicle parts reinstallation
Inspection Parts
Negative battery cable
Rear combination light
Function restore procedure
after removal/installation of
battery
― Continued backside ―
※ The term of validity for this sheet: 3 Years
MAZDA6
Inspection Items
Are the battery cables securely tightened to the
Torque check
terminals?
Is the turn light illuminated?
Are the brake lights illuminated?
Turn on/off
Are the back-up lights illuminated?
Have the vehicle's functions been restored by referring to
"Required
Operation check
negative battery cable", in the vehicle workshop manual
or the owner's manual?
Date ,
VIN.
PARKING SENSOR, REAR
C853 V7 290
(PARKING SENSOR, REAR)
C844 V7 281 (4pc. SENSOR)
Inspection
servicing after disconnecting/connecting
,
Check
Check
Check