Mazda 6 Installation Instructions Manual page 13

End of the
rear bumper slider
(1)
Outside of vehicle
Rear bumper
Tab D
(2)
Rear bumper slider
Rear bumper
(3)
3.
Rear bumper
• The figure shows the left side, however, the procedure is
4.
Tabs D
(2)
Rear bumper
5.
Pull the end of the rear bumper in the direction of the arrow (1)
shown in the figure.
CAUTION
• The rear bumper and rear bumper slider are engaged firmly.
If they are disengaged forcibly the bumper could fall and be
damaged. Perform the servicing carefully when disengaging
the rear bumper from the rear bumper slider.
• When disengaging the rear bumper from the rear bumper
slider, the rear bumper could fall and be damaged. Support
the front of the rear bumper so that it does not fall.
NOTE:
the same for the right side.
Pull the edge of the rear bumper in the direction of the arrow (2)
shown in the figure, then remove tabs D.
Remove the rear bumper in the direction of the arrow (3) shown in
the figure.
13